How to Install Above Ground Pool Liner with Deep End?

Are you having an idea about installing new above ground liner pool with a deep end and looking for installing it? Then don’t worry there is no need for specialist to install it, you can install it by your own hand by following the below steps. Here we are list out the most common step to install the above ground pool liner with deep end.

Tools needed for installing above ground pool liner with deep end:

  • A set of 18 to 24 rubber tipped clamps,
  • Tools needed for installing above ground pool liner with deep endSoft push broom,
  • Rounded end trowel,
  • Good set of screwdrivers,
  • Razor knife.

Materials needed for installing above ground pool liner with deep end:

The expandable pool liner that is ordered to fit the pool inside the dimension and the depth of new skimmer and return faceplates and gaskets.

Steps to installing above ground pool liner with deep end:

Step 1:

Drain the pool and remove the liner:

Most of the liner pools do not have a drain, so you need to drain it completely which will need the use of a pump, either a pool side or a submersible pump. Once the pump gets shuts off or starts sucking the air, then carefully walk down to the deep end and with a razor knife.

Steps to installing above ground pool liner with deep endAfter that cut the liner around the base of the wall and all around the pool. 2 people pull the liner up to drain the last bits of water to the pump. Then you need to remove the pump and then remove the liner from the floor of the pool.

Step 2:

Wall and floor preparation:

You need broom the wall and clean it from any of dust or deposits. If rust is visible, the scrape off and paint it over and you need to consider it using the wall foam. And also you need to decide if you can reuse the wall cove between the wall and the floor. Or else you need to replace the pool of the cover.

On the next step, its is to prepare the floor with the brooms and trowels to smooth out the sand reshaping areas or adding the masonry sand if it needed. And then you need to remove any bubbles or windblown debris and you need to use the tools to lower high spots and fill the low spots.

This process is starts in the deep end and work your way out of the shallow end and creating the sharp transitions on the safety ledge and shallow slope.

Step 3:

Install the liner pool:

You can unboxed the liner in a clean grassy area, and unfold it and mark the seam intersections with a duct tape, which will help you to make sure that the liner is not ‘askew’ in relation to the round or oval shape pool.

Refold the liner, accordion-style, or fan-fold it starting at the shallow end. With 4 people, carry the liner and place it on the top of the shallow end top rail.

We will be happy to hear your thoughts

      Leave a reply

      All Pools